Recalling Memory Channels - Kenwood TH-28A Instruction Manual

4
5
o
=f
20
Press the M key.
Press and hold the PTT switch and press the CALL
key.
Release the PTT switch.
Recalling Memory Channels
Press the MR key.
You can change the memory channel by the
following two methods.
Using the numeric keypad
Select any desired memory channel number
(00~39). For example, use a two digit number, such
as 02 for channel 2, or 15 for cannel 15.
Selecting the three digit memory mode
If you install the optional ME-1, you cannot recall
more than 100 memory channels in the two digits
recall mode (initial states).
You must change the function to three digit recall
mode.
Press and hold the F key for longer than one second
then press the MR key.
2 digit mode (initial state)—>3 digit mode >
1 digit mode—2 digit mode.....
2 Repeat as required until the desired mode has been
selected.
Using theTuning Control
Rotate the tuning control clockwise or
counterclockwise to select the desired Memory
Channel.
9 Memory Shift
Press the F key, then press the VFO key to copy the
contents of a memory or call channel to the VFO
without changing the data in memory. Doing this
allows you to begin tuning at the point specified by
the memory channel data.
Caution
You cannot perform memory shift if the displayed
frequency exceeds the programmable VFO setting
range (see page 14).