D-Link DNR-F4108-08P Getting Started Manual

Getting Started Guide for
D-Link Network Video Recorder (NVR)
PRODUCT QUICK INSTALLATION GUIDE
DNR-F4108-08P
DNR-F4216-16P
STEP 1.
Remove screws to open the Network Video Recorder
housing and install your SATA HDD(s).
Connect the SATA cables to the HDDs.
STEP 2.
Dimensions (mm)
Connect LAN port to your network.
Connect Cameras to PoE ports on the NVR.
NOTE: You can also connect cameras to a PoE switch
located on your LAN..
Connect your monitor to either VGA or HDMI port.
Rear Panel
Power on the NVR.
PoE LAN VGA/HDMI
STEP 3.
Wait for on-screen Setup Wizard.
Assign password to your Network Video Recorder.
Type in the channel (camera) password.
Camera's default password is "admin".
Continue the setup following the on-screen instructions.
Enter a new password:
Enter channel password:
DNR -F4226P
16CH 2HDD NVR with 16CH PoE
STEP 4.
Under the NVR network settings - enable DHCP.
Network
DHCP
Wait for the NVR to automatically discover and add
your cameras. Successfully added cameras will be
shown with a green dot.
You can also add cameras manually by selecting them
and pressing the "Add" button.
CH1
CH2
CH3
CH4
STEP 5.
Install the D-Link CCTV app on your phone and scan
the QR code to add your NVR.
You can also find your NVR's unique QR code under
Network > P2P.
Download the free
on your smartphone or tablet
Scan QR Code within the app
Camera 1
Camera 2
Camera 3
Camera 4
D-Link CCTV app
Add "P2P Device" and
QUICK INSTALLATION GUIDE | DNR-F SERIES