Table of Contents
Advertisement
Available languages
Available languages
2.
Unscrew the hex-shaped regulator cap from the regulator and
4.
Apply masking tape to the end of a %2" (7.0 mm) nut driver to
remove the regulator pin.
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A. LP gas orifice spud
Use the following chart for correct Natural gas orifice spud for
each burner. Refer to the model/serial rating plate behind the
control panel for proper sizing of Natural orifice spuds for each
burner location.
A. Regulator pin
Natural Gas Orifice Spud Chart
B. Regulator cap
Burner Rating
Color
Number
3.
Flip the regulator pin over and snap pin firmly into place.
5.000 BTU
Green
TO7N
7,300 BTU
Yellow
125N
'oko
9,200 BTU
Orange
142N
Ca)
10,000 BTU
Transparent
149N
J
_B
¥
15,000 BTU
White
180N
Af
"
Wy
16,000 BTU
Black
195N
EV
5.
Replace the LP gas orifice spud with correct Natural gas
orifice spud. See the "Natural Gas Orifice Spud Chart."
6.
Replace burner base and hand tighten the screws.
7.
Replace burner cap.
4.
Screw the hex-shaped regulator cap securely back into place.
8.
Repeat steps 1 through 7 for the remaining burners.
9
Do not overtighten.
Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
. Replace burner grates.
1.
Ifinstalled, remove the burner grates.
11. Complete installation. See "Make Gas Connection" and
Electronic Ignition System"
sections.
Remove the burner caps.
.
.
.
.
~
é
.
Checking for proper cooktop burner flame is very important.
3.
Using a Phillips T20 Torx® screwdriver, remove the burner
The small inner cone should have a very distinct blue flame 14"
base.
to Ye" long. The outer cone is not as distinct as the inner cone.
Natural gas flames do not have yellow tips.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
A. LP gas position
B. Natural gas position
To Convert Surface Burners
10
A. Burner cap
C. Burner base screws
B. Gas tube opening
D. Burner base
21
Advertisement
Table of Contents
