Ae
2
aa
()
Z
ve
YOUR SAFETY FIRST
BEFORE YOU START
* Proper installation is the installer's responsibility!
- Read the entire manual before you begin.
- The model number label is located on the oven front. See Figure 1.
- Mounting plate is located on back side of microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
Model Number Label
{__
__
0
;
(ge
rere
=
ie
jMounting plate
a
Mounting plate
screw (2 screws)
Figure |
Figure 2
FOR YOUR SAFETY:
* You will need TWO
people to install this oven. lt is heavy and could cause personal injury if not
handled properly. The dimensions of the oven are as follows:
Height
: 16-7A6 inches
Width
:
29-156 inches
Depth
: 15-% inches
Weight
: 52 pounds
* AVOID ELECTRICAL SHOCK!
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be con-
cealed behind the wall.
YOU COULD GET AN ELECTRIC SHOCK it you contact electrical wires with your drill bit.
- Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU BDO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
* ELECTRICAL RATING OF THIS OVEN:
120V, 60Hz.
13 Amps(14 Amps applys 8002)/1500 Watts (Microwave oven + Cooktop Lamp + Ventilation Fan)
- You need a 120V, 6OHz, AC only, 15A or 20A, fused electrical supply (located in the cabinet above
the microwave as close as possible to the microwave circuit) serving only the microwave.