Power Cord Replacement Instructions - Maytag MHN33PD Installation Instructions Manual

Power Cord Replacement Instructions

The steps in this section shall only be performed by a Maytag
service person, qualifi ed electrician, or similarly qualifi ed person.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. The appliance shall be disconnected from the power
supply before servicing. Read all instructions before any
disassembly.
2. Remove retaining screw securing power cord assembly to the
product and save for re-installation.
3. Rotate the power cord strain relief bracket within the machine
console and remove at an angle from the opening in the
back panel to expose access to the inner connector. The
inner connector is still connected. Do not put strain on the
conductors while removing the bracket to allow access to the
connector.
Remove at
Angle
Outside Product
8
Twist
Inside Product
4. Disengage the supply connection within the product by
depressing the connector clip to release the power cord from
the appliance.
5. Remove the U-Clip from the strain relief bracket by sliding
downward and save for re-installation.
6. Remove the cord from the strain relief bracket and follow the
cord installation steps 7-12. Save the strain relief bracket for
re-installation.
Power Cord
Retaining
Screw
7. Select the regionally required cord/plug and slot it through the
strain relief bracket.
Press
U-Clip
Strain Relief
Bracket