Assembly - Husqvarna ECA308 Operator's Manual

1. When fitting, tighten the locknut in the
opposite direction to the direction of
rotation of the cutting attachment. To
remove it, undo the locknut in the same
direction as the cutting attachment rotates.
2. Put a small screwdriver or locking pin (A)
in the hole on the drive disc to lock the
blade.
3. Tighten the locknut to a torque of 11-15
ft-lb / 15-20 Nm.
Safety instructions for maintenance
WARNING:
instructions that follow before you
use the product.
To install the shaft into the gearbox
1. Loosen the clamp screw (A) and remove
the set screw (B).
A
B
2. Align the arrow on the shaft with the set
screw hole in the gearbox.
3. Push the shaft until the line mark (C)
touches the gearbox.
4. Align the set screw holes in the shaft and
the gearbox.
5. Replace and tighten the set screw.
10
A
Read the safety

Assembly

C
• Always stop the engine/motor before you
do work on the cutting attachment. The
blade continues to move after the throttle/
power trigger is released. If you have
a gasoline operated product, remove the
spark plug cap from the spark plug. If you
have a battery operated product, remove
the battery. Make sure that the cutting
attachment has stopped fully before you do
work on it.
• Always wear heavy duty gloves when you
repair the cutting attachment. This is very
sharp and can easily cause cuts.
• Use only original spare parts for repairs.
• Keep the product away from children
SAVE THESE
INSTRUCTIONS
6. Tighten the clamp screw.
To adjust the cutting depth of the
cutting attachment
The cutting depth of the cutting attachment
must be adjusted before starting work.
1. Loosen the wing nut.
2. Set the desired cutting depth.
2105 - 001 - 07.08.2023