General Information; Safety Information - Philips FW-C70 Manual

GENERAL INFORMATION

7
Your system consists of materials which
General Information
can be recycled and reused if
• The typeplate (which contains
disassembled by a specialized company.
the serial number) is located at
Please observe the local regulations
the rear of the system.
regarding the disposal of packaging
• Recording is permissible if
materials, exhausted batteries and old
copyright or other rights of third
equipment.
parties are not infringed.
• This device complies with the
Accessories
Federal Communications
Commission (FCC) rules, part 15 – Remote control
and with 21 CFR 1040.10. – Batteries (two AA size) for remote
Operation is subject to the
following two conditions: – AM loop antenna
– This device may not cause – FM wire antenna
harmful interference, and – AC power cord
– This device must accept any – SS-115 surround speakers (for model
interference received, including
interference that may cause – SS-107 surround speakers (for model
undesired operation.
Environmental
Information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).
pg 01-28/C50-C70/37-Eng 7

Safety Information

• Before operating the system, check
that the operating voltage indicated
on the typeplate (or the voltage
indication beside the voltage
selector) of your system is identical
with the voltage of your local power
supply. If not, please consult your
(Supplied)
dealer. The typeplate is located at the
rear of your system.
• When the system is switched on, do
control not move it around.
• Place the system on a solid base (e.g.
a cabinet).
• Place the system in a location with
adequate ventilation to prevent
FW-C70 only) internal heat build-up in your system.
Allow at least 10cm (4 inches)
FW-C50 only) clearance from the rear and the top
of the unit and 5cm (2 inches) from
the each side.
• The system incorporates a built-in
safety feature that prevents
overheating.
• Do not expose the system to
excessive moisture, rain, sand or heat
sources.
• Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!
Get other manuals https://www.bkmanuals.com
SAFETY INFORMATION
• If the system is brought directly from
a cold to a warm location, or is
placed in a very damp room,
moisture may condense on the lens
of the CD unit inside the system.
Should this occur, the CD player will
not operate normally. Leave the
power on for about one hour with
no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you
unplug the AC power cord and plug
it in again after a few seconds.
• To disconnect the system from
the power supply completely,
remove the AC power plug
from the wall socket.
CLASS 1
LASER PRODUCT
3139 116 19441 (ENG)
18/11/1999, 2:38 PM