Troubleshooting - Philips MAGNAVOX AZ2407 Owner's Manual

Portable cd micro system
Hide thumbs Also See for MAGNAVOX AZ2407:
Table of Contents

Advertisement

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
^
WARNING: Under no circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEM_
-
POSSIBLE CAUSE
• REMEDY
No sound/power_
-
VOLUME is not adjusted.
• Adjust the VOLUME.
-
Headphones are connected.
• Disconnect headphones.
-
Batteries are exhausted.
• Insert fresh batteries.
-
Batteries are incorrectly inserted.
• Insert the batteries correctly.
-
Pwer cord is not securely connected.
• Connect the power cord properly.
- Batteries loaded but power cord still plugged
in and connected.
Pull out the power cord from the MAINS
outlet and the set.
Reversed left and right sound/no sound
from one speaker_
-
Speakers incorrectly connected
• Connect properly: L to left, R to right
Poor bass sound_
-
Speakers not in phase.
• Connect speaker poles correctly,
V
pole (red
marked wire) to
V;
-'pole (black/unmarked
wire) to.
CD playback does not work_
-
CD is badly scratched or dirty.
• Replace or clean the CD, see Maintenance.
-
Laser lens steamed up
• Wait until lens has acclimatized
The CD skips tracks_
-
CD is damaged or dirty.
• Replace or clean the CD.
-
PBOGRAM/SHUFFLE is active.
• Switch off the PROGRAM/SHUFFLE function.
Poor cassette sound quality_
-
Dust and dirt on the heads, capstan or
pressure roller.
• Clean the heads etc., see Maintenance.
-
Use of incompatible cassette types (METAL
or CHROME).
• Only use NORMAL (IECI) for recording.
Recording does not work_
-
Cassette tab(s) may be broken out.
• Apply a piece of adhesive tape over the
missing tab space.
Remote control does not function properly
-
Batteries are exhausted.
• Insert new batteries.
-
Batteries are incorrectly inserted.
• Insert batteries correctly.
-
Distance or angle between the set is too
large.
• Reduce the distance or angle.
The type plate is located on the base of the set.
18

Advertisement

Table of Contents
loading

Table of Contents