Advertisement
Quick Links
CX-44
Technical Support - Application Assistance
or Place an Order - Contact Ramco
WARNING
Never use this product as a sensing device for personnel protection.
In case of using sensing devices for personnel protection, use
IEC etc., for personnel protection applicable in each region or country.
1
INTENDED PRODUCTS FOR CE MARKING
under
2
PART DESCRIPTION
Used when adjusting
distance
Lights up under the stable light
condition or the stable dark condition
Turn the
3
MOUNTING
The tightening torque should be
4
WIRING DIAGRAMS
NPN output type
Load
Output
-
Function
BGS function
Solid line
FGS function
INSTRUCTION
MANUAL
Lights up when the sens-
ing output is ON
L: Light-ON
D: Dark-ON
gradually and lightly with
screw with washers
Sensor
bracket
PNP output type
-
Output
Load
Sensing object contacts the background
Output operation is udes when detection-OFF
5
DISTANCE ADJUSTMENT
Step
1. Turn the sensitivity adjuster fully.
BGS function: Counterclockwise
FGS function: Clockwise
2. BGS function: In the object present
condition, turn the sensitivity ad-
the sensor enters the sensing state.
FGS function: In sensing back-ground
condition, turn the sensitivity adjuster
sensor enters the non-sensing state.
3.
ing object, turn the sensitivity adjuster
sor enters the non-sensing state.
FGS function: In the object present
point B where the sensor enters the sensing state.
If the sensor does not enter the "Light" state operation even when the
sensitivity adjuster is turned fully clockwise, the position is point B.
4.
6
CAUTIONS
This product has been developed / produced for industrial use only.
Make sure to carry out wiring in the power supply OFF condition.
Verify that the supply voltage variation is within the rating.
power supply is connected to an actual ground.
conductor area cable. However , the extension of a power
supply line and the output line of
Make sure that stress by forcible bend or pulling is not
applied directly to the sensor cable joint.
Do not run the wires together with high-voltage lines or power lines or put
the power supply is switched ON.
This sensor is suitable for indoor use only.
Do not use this sensor in places having excessive vapor, dust,
organic solvents such as thinner, etc., strong acid, or alkaline.
7
RoHS DIRECTIVE
Ramco Innovations (800) 280-6933
www.sunx-ramco.com
nsales@ramcoi.com
<BGS>
<FGS>
1
1
2
2
B
B
4
4
-
position
-
B
B
-
-
2
-
-
-
Advertisement
