Table of Contents
Advertisement
Available languages
Available languages
Option 2, No waste disposer - with air gap:
].
Cut end of drain hose if needed (do not cut ribbed section).
2.
Attach drain hose to air gap with large spring-type clamp. If
the drain hose was cut, use a 11/2" to 2" (3.8 to 5 cm) screw-type
clamp*.
3.
Use a rubber hose connector* with spring or screwtype clamps*
to connect air gap to waste tee.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
Drain hose -
cut here if needed
Rubber hose
connector
Air gap
Spring of
screw-type
clamps
Large
spring-type
clamp
Drain
Drain trap
hose
4.
Insert drain hose through
hole cut in cabinet to the
front center of opening
where drain connection
will be made.
*Parts available from local
plumbing supply stores.
Option 3, Waste disposer - no air gap:
J.
Remove the disposer knockout plug. Do not cut end of drain
hose.
2.
Attach drain hose to disposer inlet with large springtype clamp.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed. It
is recommended that the drain hose be looped up and securely
fastened to the underside of the counter.
Large spring-type
3.
Insert drain hose through
hole cut in cabinet to the
front center of opening
where drain connection will
be made.
Drain hose
Option 4, No waste disposer - no air gap:
].
Cut end of drain hose if needed (do not cut ribbed section).
2.
Attach drain hose to waste tee with 142" to 2" (3.8 to 5 cm)
screw-type clamp*,.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed. It
is recommended that the drain hose be looped up and securely
fastened to the underside of the counter.
Drain hose -
cut here if needed
Screw-type
Drain
hose
Drain trap
3.
Insert drain hose through hole
cut in cabinet to the front
center of opening where drain
connection will be made.
Drain hose
*Parts available from local
plumbing supply stores.
i,
Prepare cabinet opening where there are no
Electrical connection
Option 1, Direct wire method:
Helpful Tip: Wiring the dishwasher will be easier if you route
wire into the cabinet opening from the right side.
1.
Drill a %4" (1.9 cm) hole in
right-hand cabinet side, rear
or floor. Preferred and
optional locations are shown.
2.
Wood
cabinet: Sand the hole
until smooth.
Preferred
locations
Optional
locations
Metal cabinet: Cover hole
with grommet, (Part Number 302797 - not provided.)
3.
Run wire into house wiring junction box.
A.
Install a UL Listed/CSA Approved clamp connector (strain
relief) for flexible-type wire. If installing conduit, attach a UL
Listed/CSA Approved strain relief to the junction box.
5.
Run other end of wire
through cabinet hole. Cable
must extend to the right
front of cabinet opening.
Advertisement
Chapters
Table of Contents
