Chapter6 Parameter Setting; Procedure For Parameter Setting And Data Link Startup - Mitsubishi Electric MELSEC QS Series User Manual

6
PARAMETER SETTING

CHAPTER6 PARAMETER SETTING

This chapter explains the parameter setting that is required to perform data link in the CC-
Link Safety systems.

6.1 Procedure for Parameter Setting and Data Link Startup

The following explains the procedure for setting the parameters and starting the data link.
For procedures for starting operations after the parameter setting, refer to Section 7.1.
(1) Power on
Turn on the safety power supply module.
(2) Confirm Safety CPU operation mode
Check the LEDs on the safety CPU module to see that TEST MODE
is active. When it is in TEST MODE,
"TEST LED" on the safety CPU module is ON.
(3) Change to Safety CPU operation mode
Use GX Developer to change the current operation mode to TEST MODE.
For how to change to TEST MODE, refer to QSCPU
User's Manual (Function Explanation, Program Fundamentals).
(4) Set parameters
In GX Developer, select in order of "Parameter", "Network Parameter",
"CC-Link" to display the "Network parameter CC-Link
list settings" screen, and set network parameters.
(Refer to Section 6.3.)
(Refer to Section 6.3.)
(5) Write to PLC
In GX Developer, perform write to PLC to write the network
parameters to the safety CPU module. After that, switch the power of the
PLC from OFF to ON, or cancel the reset state of the PLC.*
*
"PARAMETER ERROR" (error code: 3008) occurs on the safety CPU module if a
remote station is powered ON from OFF or is reset without switching the PLC
power from OFF to ON or canceling the reset state of the safety CPU module
after writing the network parameters.
Start
TEST MODE?
Not in TEST MODE
End
6.1 Procedure for Parameter Setting and Data Link Startup
TEST MODE
1
2
3
4
5
6
7
8
6
- 1