Setting Up The Display - Sony XAV-AX8500 Operating Instructions Manual

 Setting up the display

The mounting positions of the display can be
adjusted.
Depth Height
(within 20 mm
(within 60 mm
( 13 / in), in 3 steps) (2 3 / in), in 7 steps)
16 8
Angle (swivel)
(-15° to +15°, continuously)
Width
(within 25 mm (1 in), in 5 steps)
Adjusting the depth of the display
position
1
Loosen the 3 pre-installed screws for depth
adjustment (on top and both sides).
Pre-installed screws
Slightly loosen the screws until you can slide the
connector bracket. Do not remove the screws
from the bracket. Doing so may damage the
parts.
2
Angle (tilt)
(-15° to +15°,
continuously)
3
Adjusting the display angle (subtilt)
1
Slide the connector bracket to decide the
appropriate depth position.
Adjustable depth: within 20 mm (
3 steps, in 10 mm ( 13 /
32
Bracket positions 1 to 3 for the display:
1: Slide-out position
2: Intermediate position
3: Slide-in position
At the desired position, tighten the 3 screws
firmly to secure the connector bracket.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be from
1.5 N•m to 2.0 N•m).
Remove the 2 pre-installed screws for angle
adjustment (on both sides).
13 / in) (), in
16
in) pitch ().
3 2 1
Pre-installed screws
17
EN