LED light wand
User Manual
I. LOADING BATTERY:
1. Unscrew the button by twisting the end cap
counterclockwise. A coin or flat screwdriver
(not included) may be used if needed.
2. Push out the inner casing from the tube and
insert 3 AAA batteries (not included), noting the
correct polarity. Insert the casing back into the
tube and screw the end cap back on (see Fig. 1).
Fig. 1
Note: Remove batteries when not in use.
II. LIGHT MODE SELECTION:
Press the ON/OFF button to
cycle through to the preferred
light mode (see Fig. 2). This light
offers 3 modes for use: ON (full
brightness), ON (dim), and OFF.
III. INSTALLATION:
1. Mount the light in the desired position using the
double-sided tape (included) (see Fig. 3) or by
using a screw (included). Note the diagram in
Fig. 4 for proper installation using a screw.
Fig. 3
TAPE
3 x AAA
On/Off
Fig. 2
button
2. Turn the power on and set the mode you need.
3. Snap the light tube into the stand clip.
Fig. 4
IV. FEATURES:
This device can be mounted nearly anywhere,
and can be positioned vertically or horizontally.
Additionally, the light can be detached from the
base to be used as a handheld utility light.
MADE IN CHINA
GE is a trademark of General Electric
Company and is under license by Jasco
Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a 90-day
limited warranty. Visit www.byjasco.com
for warranty details.
Questions? Contact our U.S.-based
Consumer Care at 1-800-654-8483
between 7AM - 8PM CST.
360°
WARNING
• BATTERIES MAY LEAK HARMFUL
LIQUIDS OR IGNITABLE MATERIALS
OR EXPLODE CAUSING INJURY
AND PRODUCT DAMAGE
• DO NOT MIX OLD AND NEW OR
OTHER BATTERY TYPES
• REPLACE ALL BATTERIES AT THE
SAME TIME
• REMOVE BATTERIES IF PRODUCT
IS TO BE UNUSED FOR EXTENDED
PERIODS OF TIME
12747 Manual v4
THIS PACKAGE
12/10/18 DM
IS RECYCLABLE