Table of Contents
Advertisement
$28
8 SO
BASIC FUNCTIONS
REMOTE CONTROL
POWER SUPPLY
[Switching on and off/standby
Push the POWER button.
—» The display lights up. If the set runs from batteries the
display wil! not be back-lit.
The set is switched off when the POWER button is released.
In order to switch off the power supply, remove the mains plug.
Note: If you run the set from batteries, always be sure to switch the
set off after use. This will avoid unnecessary power consumption.
eer
isting volume and sound
Adjust the volume using the control VOLUME MIN-MAX.
Adjust the volume using the controls VOLUME W a.
—» Display indication: Volume level from 0 to 32.
Adjust the sound to suit your taste by pressing the button DSC
several times (DBB is Dynamic Bass Boost).
—» A light indicates either DBB-JAZZ-POP.
Create a phenomenal surround sound effect by pressing
INCREDIBLE SURROUND.
. —» The INCREDIBLE SURROUND button lights up.
Do not cover any vents and leave sufficient room around the unit
for ventilation.
Note: The effect of INCREDIBLE SURROUND may vary
with different types of music.
to select CD functions
to select tuner functions
CD: to key in a track number
TUNER: to key in a preset station
to start and to interrupt CD play
to play a CD in random order
CD: to select the beginning of the
current/previous or a subsequent track
TUNER: to select a radio preset station
Ms edendiactaciiance to stop CD play
OPENS secisiieiassas to open/close the CD tray
VOLUME ¥ &............. to decrease or increase the volume level
Notes: — Always select the desired sound source first and then press the required function key.
— Numbers consisting of two figures must be keyed in within 2 seconds.
—DISC UP has no function with this set.
For the set (optional):
Open the battery compartment of the set and insert six batteries,
type R20, UM1 or D-cells (preferably alkaline).
For the remote control (supplied):
Open the battery compartment of the remote control and insert two
batteries, type R06, UM3 or AA-cells (preferably alkaline).
Remove the batteries if they are flat or the set is not going to be
used for a long time.
Batteries contain chemical substances, therefore they
should be disposed of properly.
1 Check whether the mains voltage as shown on the type plate
==
corresponds to your loca! mains voltage. If it does not, consult
Ne
S Paaey!
your dealer or service organisation. The type plate is located |-—-——=--- -|
on the base of the set.
if the set is equipped with a VOLTAGE selector (), set this
selector to the local mains voltage.
2 Connect the mains cable to the AC MAINS inlet and the wall
socket. This switches on the mains supply. The mains cable is
inside the battery compartment.
The battery supply will be switched off when the set is connected
to the mains. To change over to battery supply, pull out the plug
from the unit's AC MAINS socket.
To disconnect the set fram the mains completely, remove the mains
plug from the wall socket.
For users in the U.K.: please follow the instructions on page 2.
ASN
HO4
NOLLONY.LSNI
eu}
Jo }disoxe
joug
S-?%
Advertisement
Table of Contents
