Set-Up Adjustments; Signal Adjustment: Ou; Dsasdess; Pal Auto Adjustment (Cvbs) - Sony KLV-S40A10E Service Manual
Flat panel color tv
Hide thumbs
Also See for KLV-S40A10E:
- Service manual (106 pages) ,
- Operating instructions manual (191 pages) ,
- Installation manual (33 pages)
Table of Contents
Advertisement
WAX
RM-EA002/RN-EDOO2
SECTION 3 Set-up ADJUSTMENTS
3-1. Signal Adjustment
Service adjustments to this model can be performed using the
supplied remote Commander RM-EA002 or RM-ED002.
How to enter into the Service Mode
ae:
>
—_
Turn on the power to the TV set and enter into the stand-by
mode.
Press the following sequence of buttons on the Remote
Commander.
2
iH) 9/5)9/+]9(C is
(ON SCREEN
(DIGIT 5)
(VOLUME +)
m™
DISPLAY)
'TT—' will appear in the upper right corner of the screen.
Other status information will also be displayed.
Nv
3.
Press 'MENU' on the remote commander to obtain the following
menu on the screen.
Trident SVP EX
Chroma Decoder
Backlight
Sound
IF Adjust
AV Switch
Service Menu
Error menu
WAX
v0.18
Factory data: 11111111
Serial Number: 4294967295
Working Time: 9:15
4.
Move to the corresponding adjustment item using the
up or down arrow buttons on the Remote Commander.
3
wn
Press the right arrow button to enter into the required menu item.
6.
Press the 'Menu' button on the Remote Commander to quit the
Service Mode when all adjustments have been completed.
Note :
¢ — After carrying out the service adjustments, to prevent the
customer
accessing the 'Service Menu' switch the TV set OFF
and then ON.
3-1-1.PAL auto adjustment (CVBS)
1.
Select AV1 and input PAL signal. (PAL CVBS: CB 75%Y/75%C
from signal generator).
Set the TV in Service Mode (See above) and send "TT51"
command.
3-1-2.PAL auto adjustment (RGB)
1. Select AV1 and input RGB signal. (PAL RGB: CB 100% Y/100%C
from signal generator).
2.
Set the TV in Service Mode (See above) and send "TTS2"
command.
3-1-3.SECAM auto adjustment (CVBS)
1. Select AV1 and input SECAM signal. (SECAM CVBS: CB 75%Y/
75%C from signal generator).
2.
Set the TV in Service Mode (See above) and send "TT53"
bo
command.
Note:
¢
While Auto adjustment is in process the RED LED is ON, till it
finishes.
-24-
1.
3-2.White Balance Adjustment
3-2-1. White Balance adjustment (H/L)
Select AV 1.
Change the TV to Custom Mode and set the following registers by
sending "TT54".
[comm fe
Ce
een
a ae
fl
Input PAL CVBS 60 IRE Full Field Signal to AV1.
Adjust Highlight registers:
NORMAL_PAL_RD
(R Drive)
NORMAL_PAL_BD
(B Drive)
High light adjustment value (9300K-OMPCD)
Advertisement
Table of Contents
