Panasonic DVCPRO AJ-D455P Service Manual page 380

Tool connector
16-2-2. Version Upgrade Procedure
1. Boot up the personal computer in the condition which "16-2-1. Version Upgrade Preparations" is completed.
2. Turn on the power of the AJ-D455P. Confirm that the LED1 and LED2 on the DIF board should be OFF.
3. Start the flash memory version up software.
(Double-click the program file "VSI2312E.EXE", which had been copied to arbitrary directory, or create a
shortcut to "VSI2312E.EXE" and double-click the shortcut.)
4. When this program is started, the "Setup Panel" will open as shown below.
5. Perform the following settings on the "Setup Panel".
• Microcomputer select........................... M16/12 Series. V853/852 Series
• Writing data .......................................... File data
• Target machine ID check ..................... OFF
• Port....................................................... Set the port which the RS-232C cable of the personal computer is
• Baud Rate ............................................ 56000
• Stop Bits............................................... 1Bit
• Byte Size .............................................. 8Bits
• Parity .................................................... None
Flat cable
Blue side
t
Enter the new software (XXXX.mot) for the version upgrade with the
full path. You can also use the "Browse..." button on the "Setup
Panel" to select the file name and the location of the new software.
connected to.
Connector on the circuit board side
Blue side on top
INF-46
Flat cable