Motorola RLN4780 Quick Start Manual

RLN4780
Remote Mount Kit
(excluding Cable Kit)
Professional Radio
Remote Mount Controlhead Installation
Lh
CAUTION: The radio must be disconnected from the power supply before
commencing any disassembly.
For installation in environments where water or dust are present, the
Remote Mount must be mounted with the speaker grill facing down.
The Installation Manual should be referred to for more detailed information
on warnings and safety.
To Disassemble the Radio from the Control head
1. Remove the Controlhead from the Transceiver by inserting the dismantling tool in the
recess between the Controlhead and the Transceiver.
2. Split the Controlhead into Front and Back housings by inserting the dismantling tool in
the recess between them.
NOTE 1. To minimise cosmetic damage disassemble from the bottom side, (label side) .
2. The flex and Controlhead Back Housing are not required for remote mounting.
3. Remove the flex .
To Assemble the Remote Front Housing:
1. C.onnect the flex from th.e Remote Front Housi[1g to the top small con.nector in the
Transceiver.
NOTE For correct orientation of the flex in the Transceiver, the "plastic" tab should be up,
contacts facing down . Align the '0' on the flex with the '0 ' on the Transceiver. The
flex must be pushed into the connector until it meets the stop.
2. Press the Remote Front Housing onto the Transceiver chassis until the 4 chassis tabs
snap into place.
To Assemble the Remote Back Housing
1. Connect the flex from the Remote Back PCB to the Controlhead.
NOTE For ·correct orientation of the flex, align the '0' on the flex with the '0' on the PCB.
2. Orientate the Controlhead in the Back Housing, to suit the mounting position .
3. Press the Controlhead onto the Remote Back Housing until ALL tabs snap into place.