Vcr And Cassette Information (Record Tab, Tape Speeds, Head Cleaning, D.s.t., Specifications) - Panasonic Omnivision PV-7661 Operating Instructions Manual

Hide thumbs Also See for Omnivision PV-7661:
Table of Contents

Advertisement

VCR and Cassette Information
Erase Protection (Record Tab)
Cassettes have a record tab to ensure that
recordings are not accidentally erased.
4
To prevent accidental
erasure, break off
with a screwdriver.
>
"dh
To record again, cover the
hole with cellophane tape.
Maximum Record/Playback Time
Only use tapes with the VHS] S| mark in this unit.
2 Hours
1 Hour
40 Minutes
SLP
Build-in Head Cleaner
A clean video head helps produce a clear picture.
So, we have equipped your VCR with a built-in, non
chemical head cleaning system that helps prevent
clogging of the video heads. Cleaning is performed
each time you load or unload a video cassette.
Note: This feature is preventative only. if your video
heads are seriously clogged, consider the use of
a chemical nonabrasive head cleaning kit or take
your VCR to a Service Center.
Head Cleaning
Your VCR will not normally require head cleaning,
however the heads may become clogged when playing
an old or damaged tape.
Video Heads Sensor System
If head cleaning becomes
necessary, the VCR will
display the screen at right
recorded signal.
kd
CLEANING CASSETTE
To exit this screen, push PLAY | ón REFER TO MANUAL
on the remote control or VCR.
Use "dry" type head
cleaning cassette* only.
Be sure to follow the cleaning tape instructions
carefully. Excessive use of a cleaning cassette can
shorten head life.
If using a head cleaning cassette does not solve the
problem, contact your nearest Factory Service Center
or authorized Service Center.
* Cleaning cassette part No. NV-TCL3OPT is
recommended.
VIDEO HEADS MAY
END:PLAY
KEY
*
Reset all VCR Memory Functions
Use when moving the VCR to a new location, or if a mistake
was made in the One Time VCR Setup section.
* Make sure a tape is not inserted in the VCR.
1) Turn VCR Power on.
2) Push and hold both PLAY and CHANNEL A on the VCR
for more than 5 seconds.
* The power will shut off.
3) Perform the One Time VCR Setup section on page 14.
D.S.T. (Daylight Saving Time)
Spring (First Sunday in April)
When the VCR is set to DST:ON, it automatically adds
one hour and adjusts the clock.
NORMAL TIME
1:00 a.m.
Y a.m.
DAYLIGHT
SAVING TIME
Autumn (Last Sunday in October)
When the VCR is set to DST:ON, it automatically turns back
one hour and adjusts the clock.
DAYLIGHT
1:00 a.m.
2:00 a.m.
SAVING TIME
]
NORMAL TIME
RN
3:00 a.m.
4:00 a.m.
y
1:00 a.m.
2:00 a.m.
Specifications
Power Source:
Power Consumption:
120V AC, 60 Hz
Approx. 23 watts (Power on)
Approx. 7 watts (Power off)
Video Signal:
EIA Standard NTSC color
Video Recording System: 4 rotary heads helical
scanning system
Audio Track:
1 track (Normal)
2 channel (Hi-Fi Audio Sound)
Tuner:
Broadcast Channels:
VHF 2~13, UHF 14~69
CATV Channels:
Midband A through | (14~22)
Superband J through W (23~36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CATV channel 5A (01)
Ultraband 65~94, 100~125
Operating Temperature: 41°F~104°F (5°C~40°C)
Operating Humidity:
10%~75%
Weight:
7.7 lbs. (3.5 kg)
Dimensions:
16-15/16" (W) x 3-2/3" (H) x
11-13/16" (D)
430 (W) x 93 (H) x 300 (D) mm
Note: Designs and specifications are subject to change
without notice.

Advertisement

Table of Contents
loading

Table of Contents