Table of Contents
Advertisement
ACH550-01 User's Manual
Code Description
2108 START INHIBIT
Sets the Start inhibit function on or off. The Start inhibit function ignores
a pending start command in the following situation (a new start
command is required):
• The fault is removed and reset. This can be done manually through
control panel, I/O or serial communication, or by automatic reset
(Group 31: AUTOMATIC
0 =
– Disables the Start inhibit function.
OFF
1 =
– Enables the Start inhibit function.
ON
2109 EMERG STOP SEL
Defines control of the Emergency stop command. When activated:
• Emergency stop decelerates the motor using the emergency stop
ramp (parameter 2208
• Requires an external stop command and removal of the Emergency
stop command before the drive can restart.
0 =
– Disables the Emergency stop function through digital
NOT SEL
inputs.
1 =
1 – Defines digital input
DI
command.
• Activating the digital input issues an Emergency stop command.
• De-activating the digital input removes the Emergency stop
command.
2...6 =
2...
DI
DI
Emergency stop command.
• See
1 above.
DI
-1 =
1(
) – Defines an inverted digital input
DI
INV
Emergency stop command.
• De-activating the digital input issues an Emergency stop command.
• Activating the digital input removes the Emergency stop command.
-2...-6 =
2(
DI
INV
as the control for the Emergency stop command.
• See
1(
DI
INV
2110 TORQ BOOST CURR
Sets the maximum supplied current during the torque boost.
• See parameter 2101
2113 START DELAY
Defines the Start delay. After the conditions for start have been fulfilled,
the drive waits until the delay has elapsed and then starts the motor.
Start delay can be used with all start modes.
• If
START DELAY
• During the Start delay, alarm 2028
Parameter listing and descriptions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
RESET).
EMERG DEC TIME
1 as the control for the Emergency stop
DI
6 – Defines digital input
)...
6(
) – Defines an inverted digital input
DI
INV
) above.
START FUNCTION
= zero, the delay is disabled.
Range
0=OFF, 1=ON
-6...6
).
2...
6 as the control for the
DI
DI
1 as the control for the
DI
0...300%
.
0.00...60.00 s
is shown.
START DELAY
2...
6
DI
DI
227
Advertisement
Table of Contents
