Light Bulbs - GE Monogram ZV950 Owner's Manual

re and (;leaning
Slai*_le,s,s Sleel Hood
your
s@?ty
get0re se_wicing or cleaning unit, switch power
ott at service panel and lock the se_Mce
disconnecting i/leans to i)revent power froi/l
being switched on accidentallv. When the
service disconnecting means cannot be locked,
securely tasten a prominent warning device,
such as a tag, to the service panel.
Avant de r_parer ou de nettover votre appareil,
d_branchez le courant au niveau du panneau
de service et verrouillez les m_canismes de
d_branchement de service pour &'iter tout
branchement accidentel au courant. Si vous
ne pouvez pas verrouiller les m _canismes
de d_branchement de service, attachez
soigneusement un avertissement bien visible,
coinnle une _tiquette, au i)anneau de service.
Metal
,_rease
.filter
Clean
jilter
light
Clean tile grease filter after 30 ho/u5 of "on" time.
A red signal light will alert you when 30 hours
has passed.
Remove the grease filters and wash them
either by hand or in tile dishwasher using
non-abrasive soap.
To clean, swish the filters in hot soapy water
or wash them in the dishwasher. Do not use
abrasive cleanse_.
Replace tile filters and make sure that they are
correcfl) seated in the filter channels, A(!just as
necessary until tile red signal, light, stoi)s blinking,.
NOTE:To remove filters,
push them back and
down using the knob.
Front_
For proper operation, make
sure the filters are securely
seated into the channels,
Hood
s !_ lf (l ce s
Do not use a steel wool pad; it will scratch
the surface.
To clean tile stainless steel s/mfhce, use watch
sudsy water; a stainless steel cleaner such as Kleen
ICdng% or an all-l)urpose liquid or spray cleaner.
Alwa)'s scHtb in tile direction of tile grain. Rinse
thoroughly with a sponge or cloth and clean
water; Dry with a sott, clean cloth.
_fter cleaning, use a stainless steel polish, such as
Stainless Steel Magic <'_, Revere Col)per and
Stainless Steel Cleane_ _'_or Wenol _dl Purpose
Metal Polish _>. F ollow the product instructions
t0r cleaning the stainless steel stmfhce.
Light bulbs
To chmlge the light bulbs:
1. Remoxe tile trim ring b} turning it
counterclockwise.
2. Grasp tile bulb on tile edges and
pull it straight out.
3. Replace with the same size bulb.
These ] 2 volt, 20 watt halogen bulbs
are available at specialty lighting stores.
_sk fi)r GE bulb or equi\_dent:
Q20MR 16/C/CG40-BAB.
On some models, the lights
are located on the sides,
on the underside of the hood.
On some models, the lights are
located on the front and back,
on the underside of the hood.