Table of Contents
Advertisement
Adjusting the Position of an
Existing Start ID
You can adjust the position of previously recorded
start IDs.
START ID REHEARSAL
1
During playback, press START ID REHEARSAL
when you arrive at the existing start ID you want to
reposition.
The deck rewinds to the beginning of start ID and
Rehearsal repeats a 3-second portion.
2
Dothe steps 1 to 3 of "Accurate Positioning of Start
IDs (Rehearsal)" on page 16.
You can move the start ID to a maximum extent of
about 2 seconds (4 seconds in long-play mode) in
either direction from its original position.
Note
Start IDs written within 10 seconds from the end of the tape
may be difficult or impossible to move.
Erasing Start IDs
You can erase any start ID.
Press ERASE where the start ID you want to erase is
written.
"(ERASE)" appears in the display as the deck rewinds
to the beginning of the start ID, then "ID ERASE"
appears as the deck erases the start ID.
¢ It takes 9 seconds to erase a start ID.
* Program numbers are erased together with start IDs.
Writing Sub Codes
8
Renumbering the Program
Numbers Automatically
(Renumbering)
Renumbering searches for each start ID from the
beginning of the tape and assigns a new program
number to each one starting with 1. Use Renumbering
in the following cases:
¢ When you've added a start ID while playing the
tape.
¢ When a program number is missing due to an erased
start ID.
* When you began recording from the middle of the
tape and wrote a program number that already
exists, or when one of the the start IDs has no
program number.
START ID RENUMBER
"RENUMBER' flashes in the display and the tape is
automatically rewound to its beginning. The deck then
starts searching for start IDs from the beginning of the
tape and assigns a new consecutive program number
to each track. When the deck detects a start ID, the
deck plays the track from the start ID for 2 seconds,
then writes a new program number on the tape.
During this time, "RENUMBER' lights up and
"START ID" flashes.
After Renumbering is finished, the deck rewinds the
tape automatically to its beginning, then stops.
Note
Renumbering may not function correctly when:
¢ A blank section exists on the tape.
* The interval between two start IDs is less than 18 seconds (36
seconds in long-play mode).
¢ Astart ID exists within 10 seconds from the end of the tape.
17
Advertisement
Table of Contents
