Kenwood TH-77A Service Manual page 2

IA-ffA/E
DISASSEMBLY FOR REPAIR
1. Removing the case
1) Remove the three screws from the side faces of the case
@).
2) Remove the four screws holding the bottom plate (@) .
3) Remove the cap from the panel (@).
4) Pull up the front case off the panel side (@).
NOTE: This should be done carefully so that the FPC cabling in-
side the case is not accidentally cut.
2. Removing the control unit
1) Pull out the connector (@).
2) Remove the five knobs and three nuts (@) .
3) Detach the clamp by removing the two screws (@) .
4) Remove the two screws holding the printed board (Q).
5) Raise the contro! board by inserting a slotted screwdriver
between its underside and the front case.
NOTE: The FPC should not be pulled.