Table of Contents
Advertisement
Before Requesting Help
t
Cordless Telephone
Problem
Cause and Remedy
"No
link
to
base
Place
on cradle and
try again
" IS displayed
and an alarm tone sounds
•You are too far from the base unit
Move closer and try again
• Place the handset on the base unit and
try again
• Plug in the AC adaptor
• Raise the base unit antenna
Static, sound cuts in/out,
fades Interference from
other electrical units
• Locate the handset and the base unit
away from other electrical appliances
<P 3)
• Move closer to the base unit
• Raise the base unit antenna
• Press (FUNCTION/EXIT/CH) to select a
clearer channel
The handset does not ring
•The ringer volume is set to OFF Select
the ringer volume again (p 23)
The base unit does not ring
•The ringer volume is set to OFF Press
(RINGER/CONF) then the line button
while the unit is in the standby mode
(P 24)
The line status icons and/or
buttons do not work properly
•Check the settings (p 13-20)
•The line mode selection is incorrect
See page 19
The handset display is
blank
•The handset is in the standby mode
(p 17) Press
S,
BACK
(◄] or
FWD/EDIT (►} to turn the display on
The handset display is still
blank after pressing @,
S, BACK (3 or FWD/EDIT
B
•Charge the battery fully (p 16)
Speech is cut off in places
during a conversation using
the speakerphone
• If another cal! is received on the other
line, the conversation will be interrupted
in order to receive the Caller ID
information
87
Advertisement
Table of Contents
