Related Manuals for AEG BKS18B
Summary of Contents for AEG BKS18B
- Page 3 mportant! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
- Page 4 90°...
- Page 5 START STOP...
- Page 6 Remove battery pack before starting work machine. Click...
- Page 7 75-100 % 50-75 % 25-50 % 0-25 %...
- Page 10 0 - 54 mm...
- Page 11 Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece.
- Page 12 START a switch lock and the On-/Off switch cannot be locked in the “On” position. STOP...
- Page 14 Insert and screw to lock in place. Carry out test cut where possible.
- Page 15 Accessory can be attached to a dust extraction unit. ø 26 mm...
- Page 16 to the saw blade is necessary, use the correction screw.
- Page 18 This tool is equipped with LED lights for work piece illumination. The LED can be activated by either the trigger when the saw is running or by the handle switch without the saw running.
- Page 20 Let the tool do the work. 60mm...
- Page 21 Always work on a stable, level work piece. Guide rail sold separately: 4932430067 Guide rail adaptor sold separately: 4931416518...
- Page 22 BL18DP-X5 L1850R BL18DP-LE L1860R L1860R-LE Use AEG 18V battery and charger only For other applications, e.g. Abrasive Cutting-Off Operations or Wire Brushing other vibration values could occur. mounting hardware of the saw will run eccentrically, causing WARNING! loss of control.
-
Page 23: Transporting Lithium Batteries
Do not use abrasion disks in this machine! components need to be replaced which have not been Do not fix the on/off switch in the “on” position when using the described, please contact one of our AEG service agents (see saw hand-held. our list of guarantee/service addresses). - Page 24 SYMBOLS Safety alert Regulatory Compliance Mark (RCM). Product meets applicable regulatory requirements. Please read the instructions carefully before starting the machine. Always wear goggles when using the machine. Wear ear protectors. Wear a suitable dust protection mask. Wear gloves. Do not use force. Remove the battery pack before starting any work on the machine.
- Page 28 Techtronic Industries GmbH Techtronic Industries (Australia) Pty. Ltd. Techtronic Industries N.Z. Limited Max-Eyth-Straße 10 31 Gilby Road, 2 Landing Drive, Mangere, 71364 Winnenden Mount Waverley VIC 3149, Auckland, New Zealand 2022 Germany Australia 961096265-01B...