Table of Contents
Advertisement
Figure 76. Installing the PIB
Next steps
1.
Install the power supplu
2.
Install the air
shroud.
3. Follow the procedure listed in
System board
This is a service technician replaceable part only.
Removing the system board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the following:
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
a.
System
cover.
b.
Air
shroud.
c.
Memory
modules.
d. Processor.
e. Heatsink.
f.
Expansion card
riser(if installed).
g.
Internal PERC card
Steps
1. Disconnect all cables from the system board.
2. Loosen and remove the eight screws securing the system board.
3. Hold the system board holder and slide it toward the front of the chassis.
unit.
After working inside your
Safety
instructions.
Before working on your
or
Front PERC riser
(if installed).
system.
system.
Installing and removing system components
103
Advertisement
Table of Contents
