Advertisement
CAMERA ADJUSTMENTS
:)·
1- Park the vehicle in a safe place with a typical view to refer to.
2- Secure the vehicle's parking brake.
3-Activate the camera and display unit by turning on the ACC.
in
the vehicle.
4- Manually activate the reversing camera input of the display.
• Most display units have a dedicated menu for it.
• If required, temporarily connect the display input activation wire to a
+12 V DC source to simulate information from the vehicle's reverse
lights.
5- Carefully adjust the position of the camera for an optimal
view.
• Camera view must be centered horizontally
• Camera view must be centered vertically
-,~.
• Any upward alignment, may cause unwanted reflections with the sun.
Bumper
or
rear edge of
car
6- Lock the camera angle using the hex key.
IMPORTANT NOTES & INSTALLATION TIPS
••
·1i
• Use only the parts included with the unit to ensure proper installation.
(The use of unauthorized parts can cause malfunctions)
• Consult with your nearest dealer if installation requires:
• The drilling of holes,
• Any other modifications of the
vehicle.
~
-~
• Install the unit where it does not get in the driver's way and cannot injure the passenger.
(If there is a sudden stop, like an emergency stop)
• If this unit is installed in the passenger compartment, anchor it securely.
(So it does not break free while the vehicle is
moving,
and cause injury or an accident)
• Install so that it does not obstruct the rear field of view.
• Install so that it does not protrude from the side of the vehicle.
• Do not perform installation in rain or fog.
• When humidity is high, dry the surface to which the unit is to be attached before
installing.
(Moisture on the attachment surface reduces adhesive strength which may lead to the unit coming off)
• If the temperature of the attachment surface is low, warm it with a hair dryer of other means before
installing the camera base to improve adhesive strength.
• Do not attach the camera stand to areas on the vehicle body treated with fluorocarbon resin, or glass.
(This may result in the rear view camera falling off)
• During the 24-hour period after-installing:
• Do not apply water to the unit.
• Do not expose the unit to rain.
• Do not subject the camera to unnecessary force.
FCC COMPLIANCE STATEMENT
~:~:
'!Ii..•(,.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates,
uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
•
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Advertisement
