Hob Surround; Rectifying Faults; After-Sales Service - Bosch PKD6 F17 Series Instruction Manual

Hob surround

To prevent damage to the hob surround, observe the following
instructions:
Use only hot soapy water.
■

Rectifying faults

Faults often have simple explanations. Please read the notes in
the table before calling the after­sales service.
The electronics of your hob are underneath the control panel.
For various reasons, the temperature in this area may rise
sharply.
Display Fault
Blank There is no power supply.
All displays flash The touch controls are wet or an object is
resting on them.
Several hotplates have been used over a
"ƒ
prolonged period at high power settings.
To protect the electronics, the hotplate
has been switched off.
Despite the switch-off by
"...
tronics have become hot again. All hot-
plates have therefore been switched off.
Warning: There is a hot pan in the area of
and the heat set-
"†
the control panel. There is a risk that the
ting flash alternately.
electronics will overheat.
An audible signal
can be heard
There is a hot pan in the area of the con-
"† and audible sig-
trol panel. To protect the electronics, the
nal
hotplate has been switched off.
The hotplate was in operation for too long
"‰
and has switched itself off.

After-sales service

Our after-sales service is there for you if your appliance should
need to be repaired. We are committed fo find the best solution
also in order to avoid an unnecessary call-out.
E number and FD number:
Please quote the E number (product number) and the FD
number (production number) of your appliance when
contacting the after-sales service. The rating plate bearing
these numbers can be found on the appliance certificate.
Please note that a visit from an after-sales service engineer is
not free of charge, even during the warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0344 892 8979
GB
Calls charged at local or mobile rate.
01450 2655
IE
0.03 € per minute at peak. Off peak 0.0088 € per
minute.
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
12
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
Do not use the glass scraper.
■
In order that the electronics do not overheat, the hotplates are
switched off as and when necessary. The
display appears alternately with the
indicator.
Measure
Check the household fuse for the appliance. Check whether
there is a power cut by trying other electronic appliances.
Dry the touch controls or remove the object.
Wait a while. Touch any touch control. When
electronics have cooled down sufficiently. You can continue
cooking.
, the elec- Wait a while. Touch any touch control. When
"ƒ
can continue cooking.
Remove the pan. The fault display goes out shortly afterwards.
You can continue cooking.
Remove the pan. Wait a while. Touch any touch control. When
"† goes out, you can continue cooking.
You can switch the hotplate back on again immediately.
"ƒ , "... , or "†
• or œ residual heat
goes out, the
"ƒ
goes out, you
"...