Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
Hot surface indicator
• Comes on when the unit is turned on or hot to the touch.
• Stays on even after the unit is turned off.
• Glows until the unit is cooled to approximately 150 °F.
Cooking areas
• The cooking areas on your range are identified by permanent circles on the glass cooking
surface. For the most efficient cooking, fit the pan size to the element size.
• Pans should not extend more than ½" to 1" beyond the cooking area.
• When a control is turned on, a glow can be seen through the glass cooking surface. The
element will cycle on and off to maintain the preset heat setting, even at high settings.
• For more information on selecting proper types of cookware, refer to the section "Using the
proper cookware" on page 21.
NE595R0ABSR_AA_DG68-00433A-09_EN.indd 18
6
1
5
3
2
1. Single element: Left rear
2. Single element: Right rear
3. Dual element: Left front
4
4. Dual element: Right front
5. Warming center: Center rear
6. Hot surface indicator
Surface cooking _18
2016-03-30
8:04:15