Cleaning Of Front Panel; Wiring Arrangement - Hitachi SJ Series Operation Manual

2.

CLEANING OF FRONT PANEL

Remove the front panel and wash with clean water.
●
Wash it with a soft sponge.
After using mild detergent, wash thoroughly with clean water.
When front panel is not removed, wipe it with a soft dry cloth.
●
Wipe the remote controller thoroughly with a soft dry cloth.
Wipe the water thoroughly.
●
If water remains at LEDs or signal receiver of indoor unit, it causes
trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to detach and
reattach it.
Removing the Front Panel
1. Push the end of the right-side arm outward to release
the right tab.
2. Move the left-side arm outward to release the left tab
and then pull the panel towards you.
●
!
CAUTION

WIRING ARRANGEMENT

CAUTION
!
Please use ground wiring.
●
Do not place the ground wiring near water or gas pipes, lightning-conductor, or the ground
wiring of telephone. Improper installation of ground wiring may cause electric shock.
A circuit breaker should be installed depending on the mounting site of the unit. Without a circuit breaker, the
●
danger of electric shock exists.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow
White
Black
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with
the letter E or by the earth symbol
The wire which is coloured white must be connected to the terminal which is marked with the letter N or coloured
black.
The wire which is coloured black must be connected to the terminal which is marked with the letter L or coloured
red.
NOTE
If the supply cord is damaged, it must be replaced with the new cord obtainable at authorized service parts centers.
Cleaning and maintenance must be carried out only by qualifi ed service personnel. Before
CAUTION
!
cleaning, stop operation and switch off the power supply.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because they will damage the plastic surface and the coating.
: Earth/Ground
: Neutral
: Line
or coloured green or green-and-yellow.
Attaching the Front Panel
1. Insert the shaft of the left arm along the step on the unit
into the hole.
2. Securely insert the shaft of the right arm along the step
on the unit into the hole.
3. Make sure that the front panel is securely attached an
then close the front panel.
– 10 –