Table of Contents
Advertisement
5-2.
DEFLECTION
SYSTEM
ADJUSTMENT
Enter into the service mode.
Using the "1" or "4" buttons select the Adjust item.
3. Press the "3" or "6" button to enter the adjustment
submenu.
4. Select and adjust each item in order to obtain the
optimum image.
Nn
29 HPOS (H POSTION)
B J-LO}-LO
31 VSIZ (V SIZE)
[(O}-[O}-[e]
32 VLIN (V LINEARITY)
>
+
33 SCOR (VS-CORRECTIONIZE)
>
+
34. AFCB (AFC BOW)
35 AFCA (AFC ANGLE)
O--
36 PCMP (PIN CORRECTION)
DK~ TM -(c
37 HSIZ (H SIZE)
40 PPHS (PIN PHASE)
C-()-t
41 UCNP (UPPER CORNER PIN)
(0- Tn - ins
HN)
42 LCNP (LOWER CORNER PIN)
UC ~~
5-3.
A BOARD ADJUSTMENT AFTER IC002
(MEMORY) REPLACEMENT
Enter to Service Mode.
2.
Press commander buttons [5] and [0] (Data Initialize),
and [2] and [0] (Data Copy) to initialize the data.
3. Call each item number and check if the respective screen
shows the normal picture.
In cases where items are not well adjusted, rectify the
items with fine adjustment.
Write the data per each item number ([MUTING] + [0)).
4. Press commander buttons [8] and [0] (Test Normal) to
return the user controls to the setting that was set on
shipment from the factory (This will also cancel Service
Mode).
-38-
Advertisement
Table of Contents
