Inserting Batteries Into The Remote Control; Using The Remote Control; Ntsc/Pal Conversion - Philips DVD616K/031 Service Manual

Inserting batteries into the
Remote Control
1
Open the battery cover.
2
Insert batteries with the correct polarity as
indicated by the + and - symbols inside the
battery compar tment.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly and
kept away from children.

Using the Remote Control

Direct the remote control at the remote sensor
of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near extremely
hot or humid place.
Do not spill water or put anything wet on the
remote control.

NTSC/PAL Conversion

This player is equipped with a NTSC/PAL
conversion feature to convert the video output
of the disc to match your TV system. The
conversions supported are as below:
Disc
Type Format
DVD NTSC
PAL
VCD
NTSC
PAL
+
-
Output format
Selected mode
NTSC PAL AUTO
NTSC PAL
NTSC
PAL PAL
NTSC
NTSC PAL
NTSC
NTSC PAL PAL
Notes:
– AUTO can only be selected when using a TV
that has both the NTSC and PAL systems.
– Slight picture distortions may occur due to this
conversion. This is normal. Thus, the AUTO format is
most suitable for the best picture quality.
DVD616K IFU for /751
Preparation
9
3141 016 18911