Care And Maintenance - Kenmore 405.84126 Use & Care Manual

CARE AND MAINTENANCE

Upper filter
(take out)
Remove the
screw, then
take the lower
filter out.
Upper filter
(install)
Install the lower
filter by using
the screw
.
Strap
Power
Cord
Power Plug
IMPORTANT:
1. Be sure to unplug the unit before cleaning or
2. Do not use gasoline, thinner or other chemicals
3. Tap or hose washing may result in an electrical
4. If the power cord is damaged, discontinue unit
AIR FILTER
Fig.21
• Clean the air filter at least once every two weeks
• Removal
• Cleaning
Fig.22
• Mounting
UNIT EXTERIOR
• Use a lint-free cloth soaked in mild detergent
UNIT IDLE FOR A LONG TIME
• Remove the plug from the upper drain hole fitting.
• Carefully move the unit to a floor drain location,
• Run the unit in FAN mode for half a day in a
Power Plug
Socket
• Turn off and unplug the unit, wrap the cord and
Fig.23
• Clean and reinstall the air filters.
26
servicing.
to clean the unit.
hazard when resuming operation of the unit.
use. Take unit to a Sears or other qualified service
dealer for repair.
to prevent inferior fan operation because of dust.
The unit has two filters. Pull open the upper filter
grille, and raise the filter up and out of the unit
(Fig. 21). Loosen and remove the screw on the
lower filter grille, open the grille and remove the
lower filter from the unit (Fig. 21).
Wash the filters by immersing them gently in warm
water (about 140ºF/40ºC) with a mild detergent.
Rinse the filter and dry it in a shaded area.
Reinstall the air filters only after they are
completely dry (Fig.22).
water to clean the exterior surfaces of the unit.
Use another clean cloth to wipe the exterior
surfaces dry.
Attach the open end of the supplied drain hose to
the fitting, and place the other end so that water
flows into a floor drain (See Fig. 19 on page 12).
and remove the bottom drain plug to drain the
water from the bottom tray (See Fig. 20 on
page 12).
warm room to dry the inside of the unit and
prevent mold formation.
bundle it with the supplied strap (see Fig. 23).
Remove the batteries from the remote control.