Table of Contents
Advertisement
EN 6
3139 785 31540
3.
3.
Firmware Upgrading
3.1
Firmware Upgrading
A. Preparation to upgrade firmware:
1.
Unzip the zip-archive file
2.
Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system
Format
Recording mode : SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD
Note: Long file name is necessary for the preparation of the upgrade disc
3.
Place the content of the zip-archive into the root directory of the new CD project.
4.
Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the firmware upgrade:
1.
Hold the <Record> + <Next> buttons down and Power up the set.
2.
The tray opens and set will display:
DOWNLOAD −>..........INSERT DISC
3.
Insert the prepared Upgrade CDROM and close the tray.
4.
The set will display:
INIT DISC −> DOWNLOAD −>..........
The whole process takes less than 10 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
5.
When the upgrade is completed the tray will open automatically and the set will display:
REMOVE DISC
6.
Close the tray and the set will display:
DONE
7.
The set will go into Standby mode.
C. How to read out the firmware version to confirm set has been upgraded:
1.
Power up the set.
2.
Press <System> button on the Remote control and select {Setup} option
3.
Press <Right> button to select {System}
4.
The set will prompt you about clearing the Time Shift Buffer
5.
Select {Yes} and press <OK> button
6.
Press <Down> button several times to select {Version info}
7.
Press <OK> button
8.
The TV connected to the set will display:
DIF05_5/56299AN SV11201
BE 43.2.13 ASP1,18,1,10FP
SIT5300-FNAC6-S3_299-F536_B1
20050909-1857 dev sxc
EPG:DPMS:P_DPM
9.
Press <System> button to exit
Firmware Upgrading
: Joliet
: MODE 2: CDROM XA
Advertisement
Table of Contents
