Snmpv3 Views - Cisco WAP150 Manual

SNMPv3 Views

A DNS host name can consist of one or more labels, which are sets of up to 63 alphanumeric characters. If a host
name includes multiple labels, each is separated by a period (.). The entire series of labels and periods can be up to
253 characters long.
As with community names, this setting provides a level of security on the SNMP settings. The SNMP agent only
accepts the requests from the IP address, host name, or subnet specified here.
To specify a subnet, enter one or more subnetwork address ranges in the form address/mask length where the address
is an IP address and mask length is the number of mask bits. Both formats address/mask and address/mask length
are supported. For example, if you enter a range of 192.168.1.0/24, this specifies a subnetwork with address
192.168.1.0 and a subnet mask of 255.255.255.0.
• NMS IPv6 Address/Name — The IPv6 address, DNS host name, or subnet of the devices that can execute, get,
and set requests to the managed devices. The IPv6 address should be in a form similar to
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx (2001:DB8:CAD5:7D91).
A host name can consist of one or more labels, which are sets of up to 63 alphanumeric characters. If a host
Note
name includes multiple labels, each is separated by a period (.). The entire series of labels and periods can be
up to 253 characters long.
Step 5
In the SNMPv2c Trap Settings area, configure the SNMPv2c trap settings:
• Trap Community — Enter a global community string associated with SNMP traps. Traps sent from the device
provide this string as a community name. The valid range is from 1 to 60 alphanumeric and special characters.
• Trap Destination Table — Enter a list of up to three IP addresses or host names to receive the SNMP traps. Check
the box and choose a Host IP Address Type (IPv4 or IPv6) before adding the Host Name/IP Address.
An example of a DNS host name is snmptraps.foo.com. Because the SNMP traps are sent randomly from the SNMP
agent, it makes sense to specify where exactly the traps should be sent. You can have a maximum of three DNS host
names. Ensure that you check Enabled and select the appropriate Host IP Address Type.
Step 6 Click Apply.
SNMPv3 Views
A SNMP MIB view is a family of view subtrees in the MIB hierarchy. A view subtree is identified by the
pairing of an Object Identifier (OID) subtree value with a bit string mask value. Each MIB view is defined
by two sets of view subtrees, included in or excluded from the MIB view. You can create MIB views to control
the OID range that SNMPv3 users can access.
The WAP device supports a maximum of 16 views.
This section summarizes the critical guidelines for the SNMPv3 view configuration. Please read all the notes
before proceeding.
Note
A MIB view called all is created by default in the system. This view contains all management objects supported
by the system.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
34
System Configuration