Basic Operating Procedure - Panasonic RX-DT610 Operating Instructions Manual

PRECAUTIONS
elf the set is not used for a long period of time or is
used only from an AC mains source, remove all the
batteries to prevent potential damage due to possible
battery leakage.
eAvoid using or placing this unit near sources of heat. Do
not leave it in an automobile exposed to direct sunlight for
a long time with the doors and windows Closed as this may
deform the cabinet.
e Avoid cuts, scratches, or poor connections in the AC mains
cord, as they may result in possible fire or electric shock
hazard. Also, excessive bending, pulling or splicing of the
cord should be avoided.
eDo not unplug the AC mains cord by pulling on the cord. To
do so may cause premature failure or shock hazard.
eDo not operate the set on AC mains in a bathroom, as a
potential shock hazard may result.
To prevent possible damage to this unit
@t.oad new batteries with their polarities (® and ©)
aligned correctly.
@Do not apply heat to batteries, or internal short-
circuit may occur.
elf this unit is not to be used for a long period of time,
or used on AC mains supply, remove all batteries
and store them in a cool and dry place.
Remove spent batteries immediately.
eDo not use old and new batteries together. Also
never use an alkaline battery with a manganese
battery.
BASIC OPERATING PROCEDURE
@ Extra bass system (XBS LEVEL) control
When the extra bass system control is adjusted, the level of
the dynamic low frequency sound range is boosted.
Using this system with the graphic equalizer helps you to get
more dynamic sounds.
The extra bass system effect may be different according to
the program content of the music tape.
When you playback the music tape which was recorded with
a high level, the playback sound may be distorted. In this
case, adjust with the extra bass system control.
@ Graphic equalizer
It allows you to tailor the frequency response of the unit to
compensate for room acoustics and other factors which
affect frequency response. The overall tone can be altered
by adjusting the controls which control the following fre-
quency bands:
330 Hz, 1 kHz, 3.3 kHz, 10 kHz.
Positioning the control to the "+" side of the detent will
amplify the corresponding frequency band; the "—" side will
attenuate it.
eWhen not in use, disconnect the AC mains cord from the
AC mains outlet.
eThe Operation Switch does not separate entire unit
from mains even if in "OFF" position.
Max. 40°C
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
@ After use
Be sure to reduce the volume level, and turn off by pressing
the operation switch.
ENGL