Black & Decker BPZ12SS Instruction Manual page 7

Attaching Adjustable Legs (Fig. D – F)
NOTE: Leave all nuts and screws loose until assembly
is complete.
1. To protect the tabletop
assembling, place the tabletop assembly
a soft carpet, towel, or flattened box as shown in Fig. D.
2. Slide the end of the adjustable leg outer sleeve
10
the curved leg as shown in Fig. E. Ensure the curved
leg holes line up with the adjustable leg holes.
11
3. Place the M5 washer
the screw through the curved leg and adjustable leg
outer sleeve and tighten the screw with the hex key
as shown in Fig. F.
4. Repeat for all four adjustable legs.
Fig. D
8
Fig. E
3
10
Fig. F
3
10
8
from scratches or damage while
9
upside‑down on
12
onto the M5 leg screw
11
12
Adjusting Stand Height (Fig. G)

WARNING: Do not adjust the stand while the pizza
oven or other objects are on it. This may result in
damage or personal injury.

WARNING: Ensure all four legs are set to the same
height, otherwise the stand will be unstable, resulting
in damage or personal injury.
3
into
The stand can be set to different heights for custom use. The
lowest height is 35" (89 cm) and the highest is 45" (115 cm).
Each adjustable leg pin hole
. Slide
more customized height.
13
1. Press the adjustable leg pin
it is no longer engaged with the adjustable leg pin hole.
2. Slide the adjustable leg inner sleeve
the adjustable leg pin pops out of the next adjustable
leg pin hole and locks into place. Ensure the pin is fully
engaged with the adjustable leg outer sleeve.
3. Continue until the stand is adjusted to desired
height setting.
4. Repeat for all four adjustable legs.
NOTE: You will have to press the adjustable leg pin each
time the pin clicks into an adjustable leg pin hole.
NOTE: Do not flip stand over at this point in the assembly
process. The next step requires the stand to remain
upside down.
Fig. G
1
4
13 Attaching Bottom Shelf (Fig. H – J)
NOTE: Assistance may be required for this step as the
bottom shelf
NOTE: Leave all nuts and screws loose until assembly
is complete.
1. Flip the bottom shelf upside down and slide it between
the adjustable leg outer sleeves
2. Slide the bottom shelf holes
16
studs
Fig. I.
4
is separated by 2" (5 cm) for a
1
fully into the adjustable leg so
Highest setting
2
Lowest setting
14
is heavy and large.
3
15
over the adjustable leg
sticking out of the adjustable legs as shown in
ENglIsh
2
up or down until
as shown in Fig. H.
5