Table of Contents
Advertisement
CRT REPLACEMENT
Removal of the CRT
Caution!
High voltage should be completely discharged prior to Anode Cap removal. Since all three CRTs receive high
voltage from the Flyback Transformer, discharge simultaneously by shorting the open end of the high voltage
cable to chassis ground.
[ALL]
1. Remove the Speaker Grille. [Fig. 2-1, 2-2]
2. Remove the Front Cover.
3. Remove the Screen Assy.
4. Remove the Back Board.
[VS-4543, VS-4544]
5. Remove the Rear Board. [Fig. 2-1]
[VS-5043, VS-5044]
6. Remove the Rear Board-1. [Fig. 2-2}
7. Remove the Rear Board-2.
[VS-6043]
8 Remove the Rear Board-3. [Fig. 2-2]
9 Remove the Inner Cabinet.
[ALL]
10. Remove the Anode Lead Wires from the Flyback Transformer.
11. Remove 3 PCB-CRTs.
12. Remove 4 hex-screws @ retaining the Optical Unit. [Fig. 6-1]
13. Remove 4 screws ©) retaining the Lens.
Note: DO NOT Loosen RED screws.
14. Remove 4 screws © retaining the CRT. [Fig. 6-2]
15. Remove the Deflection Yoke from the neck of the CRT. [Fig. 6-7]
Optical Unit
Lens(B)
Lens(G)
Lens(R)
DO NOT
DO NOT
REMOVE
©
REMOVE
Advertisement
Table of Contents
