Kenwood 107VR Instruction Manual page 28

Operation to reset
normal condition.
Amplifier
Sound is not output or the volume level is
low.
The STANDBY indicator blinks and sound is
not output.
Sound is not output from one of the speak-
ers.
Sound is not output from the surround
speaker and/or center speaker, or their sound
is very small.
A hum noise is generated when the PHONO
input is selected.
System control is not available when TAPE1
or MD is selected.
System control is not available.
Display is dimly tit.
Radio stations cannot be received.
interference.
A station which was preset cannot be re-
ceived by pressing the corresponding nu-
meric key.
e The speaker cords are disconnected
@ MUTE is ON.
(The MUTE ON indicator ts blinking}
@ The SPEAKERS keys are set to OFF
e Tne TAPE 2 MONITOR key is set to ON
e@ Speaker cords are short-circuited
@ The speaker cord is disconnected
@The BALANCE control is set to an extreme
DOsition.
e The surround speaker cords and/or center speaker
cord are disconnected. .
e The Surround play mode has not been engaged.
e@ The surround and center speaker levels are set to
the minimum positions.
@ The audio cord from the turntable ts not inserted
securely into the PHONO jacks
@ The turntable is not grounded
@ "TAPE" of "MD" is not displayed.
@ Tne XS8 and SL16 modes were switched while
the AC plug is left plugged into the wall power
outlet
@ The setting 1S not correct
@ No antenna :s connected
@ The broadcast band is not set properly
@ The frequency of the desired station Is not tuned.
@ Noise due to ignition noise of an automobile.
@ Norse due to a4 inftuence from an electric appli-
ance
@ Noise due to a nearby TV set
@ The preset station belongs to a frequency that
cannot be received.
eThe preset memory was cleared because the
cower cord had been undlugged for a lona period
of time
@ Tne TUNER input is not delected.
1 Unplug the AC power plug from the wali! outlet.
e@ Please note that resetting the microcomputer clears the contents
stored in and returns to the condition when ot left the factory
TOPFVR [En}
e Connect them properly reterr:ng to "Connec-
tion of speakers" i
e@Press ihe MUTE key to OFF.
@ Set the SPEAKERS key to ON.
e@Set the TAPE 2 MONITOR key to OFF.
Set the input selector to the position other than
tuner
@ Turn the power off, eliminate the short-circuit:
Ing, then turn on the power again. 6.
@ Connect tt properly referring to " Connection of
speakers".
@ Adjust the Left/Right balance.
@ Connect them properly referring to "Connec-
tion of speakers". — 6.
@ Set the presence mode
~ 22.
@ Adjust the surround and center speaker levels
@ insert the audio cord plugs securely into the
PHONO jacks.
= a
e Connect the grounding wire to the GND termi-
nal on the rear panel.
@ Switch the display to TAPE 1 or MD._
~ 12. ~ 16.
e@ Unplug the AC plug from the wall outlet and
Switch tne XS8 or SL16 mode as required._
@ Connect an antenna. =e
e Set the broadcast band properly. 3
e@Tune the frequency of the desired station _
~ dh
e@fnstall the outdoor antenna away from the
road. ;
e Turn off the power to the appliance.
einstall the system farther away trom the TV
set.
e Preset a station with a receivable frequency.
@ Preset the station again.
Select the TUNER input.