Table of Contents
Advertisement
-ez-
Troubleshooting
I the problem persists after trying the methods below,
'contact
your nearest Sony
d e a l e r .
No picture (screen not lit),no sound
'= Make sure the pover cord is connected
securely.
'=> Operate with the buttons on the projection TV.
'=> Invert the batteries in the remote control with
the correct polarity.
> Replace the batteres with new one if they are
o> Gocco see the TV /VIDED seting is correct
'when watching TY, set to TV, and w!
w i t c h i n g
video tapes, set to VIDEOI, 2, or 3.
Ty,
'chansel. it could be station trouble.
> Pertorm
AUTO SET-UP again sing the SETUP
batt return the fairy pret conion
(page
Poor or no picture (screen it), good sound
'=> Adjust PICTURE i the VIDEO menu, (page 26)
> Adjnt BRIGHTNESS
in the VIDEO mer
4
> Kéfst convergence.
(page 19)
'=> Check antenna /cable connections.
(page
'> Perform AUTO SET UP again using the SETUP
'button to return tsthe factory preset condition.
(pege 17)
> Henove objec frm the front of he projection
'Pre MUTING sothat "MUTING® disappears
>
sothat
from the screen.
(page 22)
'= Check the MTS sting inthe ALIEIO mer
0 NEE Reese aan ot o ON ne AUDIO
3H
(pa
'=> Perform AUTO SET UP again using the SETUP
'button to return tothe factory preset condition.
(pepe 17)
No color
'=> Adjust the COLOR in the VIDEO menu. (page
cul
'=> Confirm that blackand white
is rot
Program
> Perform AUTO SET UP again using the SETUP
'button to return tothe factory preset condition.
(page 17)
A2-EN | Adeitional information
'Only snow and noise appear on the screen
'<> Check the CABLE setting in the SET UP menu.
o> Ga tre anserna/cabe
connectors (page ®)
'=> Make sure the channel is brondeasting
oo Frets TV ola button) to change the input
mode. (page 23)
Dotted
lines or stripes
'> Adjust
the artenna,
'<> Move the projection TV away from noise
sources suchas cars, neon signs, and hair-
dryers.
Double images or:
> Uses
'cable (wl
reflections
directional
outdoor antenna oF &
hen hearty mosis al
Cannot sperate menu
'> If the item you want to choose appears in gray,
you cannot
sdect it. Press TV/VIDEO
o> Garek he CABLE setting in the SET UP mera.
(page 20)
Cannot receive upper drannels (UNF) when using an
'=> Make sure CABLE is OFF in the SET UP menu.
me
'> Use AUTO PLOGRAM to add receivable
pe rer rae
eee
Cannot receive any channels when using
cable TV
'=> Make sure CABLE is ON in the SET UP men.
20)
-
for AUTO FHOGRAM
md reer
~v
seston
=a
Remote control does net operate
'= Baterag could be weak: Replace the batterie
1
'= Make sure the projection
TV's power cord is
'connected secarely to the wal outlet.
> Pres TV
when operating your
projection TV.
'= Are fuorescest lights too close to the
{TVE Move tne ft east 4 fet away iro the
'Projection TV.
Cannot gain enough volume when using a cable box
'=> Increase the volume at the cable box. Then
TV UNCHON an eat projection Fs
Projection TV matfunctions
when using the S-Link
function
'=+ Make sure theprojection
TV's power cord is
Connected secirely to the wallet
'+ Check the S-Link connection.
(page 14)
'The projection TV need to be cleaned
'Clean the projection TV with a soft dry cloth.
Never use string solvents suchas thisher or
Denzine, which might damage the finish of the
Index to parts and
controls
This section brielly describes the buttons and controls
onthe projection TV and on the remote control. For
more information,
refer to the pages next to exch
description.
Projection TV — Front
{© VOLUME +/- buttons (page 17)
'TV/VIDEO button (page 17, 18)
{© SETUP button (page 17)
(@) S VIDEO/VIDEO
2 INPUT (VIDEO/AUDIO
LOMONO)/R) jacks (page 10)
@ TIMER/STANDBY indicator (pages 22, 34)
'STEREO indicator (page 30)
& Remote sensor
(@) POWER switch (page 17)
CHANNEL +/- buttons (page 17)
A4-EN | Additional information
Advertisement
Table of Contents
