Appendix: Optional Wireless Surround Speaker System - Philips 28PW9527 Instruction Manual

Appendix: Optional Wireless Surround speaker system - Kit type no: AD902W
WIRELESS MODULE
A
B
4
2
Speakers General Source Decoder
Setup
Test tone
Front left volume
Front right volume
Centre volume
(Surround volume)
(Centre mode)
Surround speakers
(Wireless surround)
(FM transmitter)
Auto surround
Wireless transmitter module
• Switch the TV off with the power switch.
• Attach the wireless module to the back of the TV as shown.
• Connect the attached cable to the wireless module connector.
• Switch the TV on.
Surround loudspeakers
There are two surround loudspeakers supplied. One is the active loudspeaker A.
The other loudspeaker B is a passive one which has to be connected with the
active loudspeaker.
• The slide channel switch 1 at the bottom of the active loudspeaker has been
set default to channel 1 in the factory.
• Connect the active to the passive loudspeaker with the supplied speaker
cable 2. Insert the marked wire into the openings of the same coloured
connector clips on both speakers. Do not insert the wires too far.
• The Surround sound loudspeakers can be located behind or to either side of
the listener.The front of the loudspeakers do not have to face the listener.The
distance between the TV and the surround speakers should not exceed 15 m.
A
sound transmission.
• Connect the active loudspeaker to the mains with the mains cable 3.
• Switch on the active loudspeaker with the
The red indicator at the front of the active surround speaker shows that the
speaker is in standby. During sound transmission the indicator turns to green.
10-15 min. after the sound transmission of the TV has stopped, the indicator
turns back to red to indicate the low power standby.
To switch the active speaker off, use the
Setup - Speakers menu
• Press the
3
• Use the cursor down to select
• Use the cursor right to select
• Use the cursor down to select
The system has already been configured in the factory to work properly. In rare
circumstances, interference from external RF (wireless) equipments such as RF
headphones, mobile phones or remote controls for lights, may occur.Then it
may be necessary to shift to another wireless channel.
Important
Wireless surround setting are switched to the same transmitting channel.
Otherwise no sound or only a distorted sound will be heard on the surround
speakers.
• Select
433 MHz, valid for the country where you are now located.
When the TV is tuned to a channel in the neighbourhood of 864 MHz (alternatively
433 MHz), the transmitter is switched off because no RF surround sound is possible.
This is necessary to avoid interfered picture.
In rare cases, when no RF surround sound is possible or when there is too
much interference, use the wired back up solution with a 3.5 mm stereo jack.
In this case select
Peripheral Equipment, p. 20.
Optional Wireless Surround speaker system
Note: In rare occasions people moving around close to the TV may interfere with the
Ï key on the remote control.
MENU
: Always be sure that the active surround speaker (A) and the
and select the correct type of transmitter, 864 MHz or
FM transmitter
in the Wireless surround menu item. See Connect
Off
switch 4.
POWER
switch.
POWER
.
Setup
.
Speakers
.
Wireless surround
23