Presetting Radio Stations - Sony R-D-S EON STR-D365 Operating Instructions Manual

1 Qc
Receiver Operations
Key If an FM stereo programme is distorted
The STEREO indicator flashes. Press FM MODE to change
to monaural (MONO). You will not have the stereo effect
but the distortion will be reduced. To return to stereo
mode, press this button again.
se.
ey If you cannot tune in.a station.and the.entered
numbers are flashing
Make sure you've entered the right frequency. If not,
press DIRECT and re-enter the frequency you want.
If the entered numbers still flash, the frequency is not used
in your area.
Key To watch FM simulcast TV programmes
Make sure that you tune in the simulcast programme both
on the TV (or the VCR) and on the receiver.
ote
"@ If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down to
the closest covered value.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 9 kHz intervals
Receiving broadcasts by scanning stations
(automatic tuning)
If you don't know the frequency of the radio station
you want, you can have the receiver scan all the
receivable stations to locate the one you want.
1. Press TUNER.
The last received station is tuned in.
2 Press BAND to select FM or AM.
3 Press TUNING/CHARACTER + or — (or TUNING
+ or — for STR-D265).
Press the + button for a higher station number;
press the — button for a lower one. When you tune
past either end of the band, the receiver
automatically jumps to the opposite end. Every time
a station is received, the receiver stops scanning. To
continue scanning, press the button again.
SS ee ee]
Presetting Radio Stations
You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B, C) and numbers (0 - 9). For example, you can store a
station as preset number A1, B6 or C9, etc.
TUNING/
CHARACTER
Numeric buttons CHARACTER MEMORY (TUNING)
TUNER SHIFT
1. Press TUNER.
The last received station is tuned in.
2 Tune in the station you want.
If you are not familiar with how to tune in a station,
see "Receiving Broadcasts" on the previous page.
3 Press MEMORY.
"MEMORY" appears for a few seconds.
Do steps 4 and 5 before "MEMORY" goes out.
4 Press SHIFT to select a character (A, Bor C).
Each time you press SHIFT, the letter "A," "B" or
"C" appears in the display.
if "MEMORY" disappears, start again from step 3.
3 While MEMORY is displayed, press the number you
want to use (0 to 9).
6 Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Note
If the mains lead is disconnected for more than one month, the
preset stations will be cleared from the receiver's memory, and
you will have to preset the stations again.