Electrical Connections; Transmitter (Tx); Receiver (Rx) - ABB Orion1 Base Original Instructions Manual

5 Electrical connections

All electrical connections to the transmitter and the receiver are made through a male M12 connector located on the
lower part of the two units, a M12 4-pole connector for the transmitter and a M12-8 pole connector for the receiver.

5.1 Transmitter (TX)

1
Pin Wire Function
1 Brown Supply
2 White TEST
3 Blue Supply
4 Black Not used
1
Colors according to ABB Jokab Safety standard cables

5.2 Receiver (RX)

1
Pin Wire Function
RESET/
1 White
ACKNOWLEDGE
2 Brown Supply
EDM
3 Green
SELECTION
4 Yellow EDM
5 Grey OSSD1
6 Pink OSSD2
7 Blue Supply
8 Red RESET MODE
1
Colors according to ABB Jokab Safety standard cables
2TLC172287M0201 Rev B
2015-09-17
Connection to
+24 VDC
NO contact to +24 VDC if to be used
Not connected or 0 V if not to be used
0 V
-
Auto. Reset with no function
Auto. Reset with Acknowledge
function or Alignment mode
Manual Reset
Activate EDM
Deactivate EDM
Function used/activated
Function not used/deactivated
Automatic Reset
Manual Reset
20
Connection to
Not connected or 0 V
NO contact to +24 VDC
NO contact to +24 VDC
+24 VDC
Not connected or 0 V
+24 VDC
NC contact of a force-guided
relay
Not connected or 0 V
Safety control module for ex.
Safety control module for ex.
0 V
Pin 5 (OSSD1)
Pin 6 (OSSD2)
www.abb.com/jokabsafety
Refer to
7.2
Refer to
7.1,
7.3,
6.1
7.4
7.4
7.1