Table of Contents
Advertisement
4.8 Set Temperature Format
The temperature reading from the temperature sensor at the back
of the Baby Unit will be displayed at the top of the Parent Unit LCD
screen. You can switch temperature format between Centigrade and
Fahrenheit as follows:
1.
Press the M button and the menu bar will pop up.
2. Scroll + UP /- DOWN to
3. Press the + UP button or - DOWN button to select
4. Press M button to exit.
4.9 Add Camera (Registration)
The Baby Unit(Camera) is pre-registered to your Parent Unit. You do
not need to register it again unless the Baby Unit (Camera) loses its
link with the Parent Unit.
To add a new compatible camera to the Parent Unit, proceed as
follows:
1.
Press the M MENU button and the menu bar will pop up.
2. Scroll + UP /- DOWN to
the camera list
3. Press the + UP or - DOWN button to select the desired amera,
and press the O/
with "press PAIR on cam" shown.
Note: If a baby unit is currently paired with the Parent Unit, its
camera location (with a
new registration.
4. Press and hold the PAIR button on the rear of the camera until
the Parent Unit finds the camera, beeps and PAIR OK appears
on the screen. The video from the camera will then appear.
NOTE
If a particular Baby Unit was registered previously, registering this
current Baby Unit again will cancel its old registration.
18
then confirm with O/
then confirm with O/
1
2
3
4
appear on the screen.
button to start searching for a camera unit,
against it) cannot be selected for a
button.
o
o
C or
F.
button,
Parent Unit Menu Options
Advertisement
Table of Contents
