Table of Contents
Advertisement
Chapter 2 Basic Operations
Operating with the Remote Commander
Before operating the equipments with the remote commander, be sure to set the
receiver to the desired mode by pressing one of the FUNCTION buttons.
The FUNCTION buttons are factory set in the following list.
pressed
ee
¢ When VIDEO 1, 2 or 3 is pressed, the power of the
selected video equipment and TV is turned on.
Operating the equipment
1 Press the desired FUNCTION.
2 Press <4 (only for tape deck) or > to start playback.
(Or erchalesialomealsmel=100(a le lowe) tal-m mel
OB LOINMSiUlacolals
With the SELECT button, you can replace the functions
stored in the FUNCTION buttons.
To change the settings of the FUNCTION buttons
1 Press one of the FUNCTION buttons to be stored.
2 Press SELECT by using the pointed tool.
3 Press 1 to 9 button to select the desired function within 30
seconds.
With the numeric buttons from 1 to 9, the each function
can be selected as described below:
Numeric buttons
| The function to be selected
to be pressed
4
7
|
2
=i: DAT deck
DECK A
DECK B
| 1
| cD player
TV
To reset to the initial state, press the >10 button.
Note
The 0 and ENTER buttons do not function.
List of operative buttons in SYSTEM mode (When setting
the SYSTEM/TV selector to SYSTEM)
oe ES oe ae Es ee
ee
e; The button is operative.
— The button is not operative.
e*; The button can operate TV.
Note
To operate the unit correctly, the function mode of the
receiver should be same with that of the remote
commander. So, be sure to press the desired FUNCTION
button at first and then the operative button.
| 5
Advertisement
Table of Contents
