Kenwood 106VR Instruction Manual page 22

: To improve the feeling of presence in the surround modes,
. various parameters of each surround mode can be set up
- according to the speaker system used as well as to the
- environmental of the listening room. The following proce-
dure let you set the parameters of the surround mode (DOLBY
PRO LOGIC, DOLBY 3 STEREO).
Once the settings have been done, it is held in memory so re-
adjustment is not necessary even after the mode has been
changed to other modes.
Adjustments for surround pla
Select the DOLBY PRO LOGIC surround mode.
PRO LOGIC
oA
@ Press the SETUP key (on the remote
control unit}.
SETUP
os
© Adjust the front speaker (left & right)
levels so that the left and right levels are
identical.
To decrease the =
lett channel sound C ~)
LEVEL ~~~
ngnt chanrel souna "7
= © Press the SETUP key again to establish |
the setup.
After this, the unit enters the condition
speaker".
for "2 Adjust the volume level of each :
' Keys or controls to be used in this operation
eSelect 4 surround mode according to the played source and your
system components.
Lights
Se -— SSSuRROUNES oy
race rpr) rit Ts
PEE Po be ea a
Each press of CENTER MODE key switches the modes as follows
1 NORMAL : When the center speaker is a compact speaker
" 2 WIDEBAND~ - When the center speaker is a large speaker.
3 PHANTOM
: When no center speaker is used
Adjustment procedure: Each press of the SETUP key switches the
adjusted items as shown below.
I Adjusting the volume level of each speaker
Adjusting the delay time
' Adjusting the front speaker balance
End of setup
To cancel setup in the middle, press the SETUP key repeatedly until the
setup mode is cancelled
Left speaker
position
Right speaker
position
Center position
indication
id cat cee Ne witerAae Wee
Balance setup