Kenwood TM-401A Instruction Manual page 6

@ HI/LOW switch
@ Display
(h)
Frequency display
Scan indicator
VFO B indicator
MR indicator
ALERT indicator
ON AIR indicator
BUSY indicator
S & RF meter
Note: Illustrated is a version other than that of Europe/England.
9 C6)
HI setting: This setting allows the transmitter to transmit power output up to 12
watts.
LOW setting: This setting allows the transmitter to transmit power output
approx. 1 watts.
id e
MF — ALERT ae ON AIR
a
UHF FM TRANSCEIVER
=, = >
a "i Um] a 3 1 3 58 Y
Lieb ea bt BUSY — LA
b € g h
During VFO A or B, frequency, for example, 435.025 (445.025 for USA) is
displayed in four digits as '' 5.025 "'.
During MR (M1 —Mb5) operation, frequency, for example, 435.250
(445.250 for USA) is displayed in four digits as '5.250'.
During COM* operation, frequency is displayed in four digits. At this time, zero
at the last digit is half size.
* European and British versions excluded
During scan operation, this dot flashes.
In operation other than scan, this dot lights to show MHz.
Lights when VFO B is in operation
Lights during memory recall operation (M1 — M65, MS).
Lights during alert operation.
Lights when transmitting.
Lights during reception with squelch opened.
This can be used to see if the channel is busy or not. «~
Indicates the incoming signal strength by LEDs during reception.
During transmission, LEDs light to show the RF output level strength.
With the HI/LOW switch HI, all LEDs light.
With the HI/LOW switch LOW, two to four LEDs light.