Performance Effect Select; Effect: On/Off O Ranae Na Auctest. Dor Ieeveanede; Effect Select, Effect Balance; Eeeeeeeees - Yamaha V50 Operating Manual

Performance effect select Effect on/off
Press [___] (OTHERS) four times.
SS Fb!
@ Function
Select a performance effect.
E Scttings
off, delayl, panl, chord, ... delay4, pan4, chord4
@ Explanation
This setting determines the effect used by this per-
formance.
There are three types of effect, and four memories
(four different settings) for each type of effect. I.e.,
the V50 remembers a total of t2 different performance
effects. (To set each effect memory, see page 111.)
Select one of the twelve performance effects from the
following.
delay (1 — 4)
You will hear an "echo" or "delayed repeat" of the
same note (or a different note) that you played.
pan (1—4)
When both L and R outputs are used, the sound will
move from side to side.
chord (1 — 4)
Playing a single note will produce a chord.
e Page | 11 explains how to set the performance effect
memories.
e If you set the performance effect to "off", there
will be no effect.
e The "delay" and "chord" performance effects apply
only to the lowest-numbered instrument that is
sounding.
e The "pan" performance effect applies to all in-
struments whose output assign is either L or R.
Note:
If the maximum notes setting is less than the number
of notes in the chord of the "chord" performance effect
memory, the chord will not sound correctly.
Instruments whose output assign is set "off" or
"L +R" will not be affected by the "pan" performance
effect.
This "performance effect" has no connection with
the "DSP effect" discussed in the following item.
Please do not confuse them.
30 Performance Edit
Press [|EFFECT}. The upper line of the display will show
the type of currently selected effect. If [BYPASS] is
pressed (the LED is lit), the display will show "BYPASS".
E Function
Turn the effect on/off for each instrument.
E Settings
off, on
Æ Explanation
When set to "on", the selected effect (see the next
function) will apply to that instrument.
Note: »
Effect on/off cannot be set for instruments whose
maximum note setting is 0 (or when DVA is used,
whose reserved note setting is "off").
Effect select, effect balance
Press [EFFECT] twice. If |BYPASS}is pressed (the LED
is lit), the display will show "BYPASS".
+]
(1) Effect select
@ Function
Select the type of effect to use. a ]
@ Settings
Select one of the following types of effect.
0: off
No effect
1: Reverb Hall
Reverberation of a large hall
2: Reverb Room
Reverberation of a smaller room
3: Reverb Plate
Reverberation typical of a plate reverb unit
4: Delay
Delayed sound
5: Delay L/R
Delayed sound spread to left/nght