Table of Contents
Advertisement
NOTE:
The thermal pad is re-usable. The thermal pad is pre-installed on systems shipped with solid-state drive. If the
solid-state drive is purchased separately, the thermal pad is not bundled with the solid-state drive kit and is to be
purchased separately.
2. Peel off the protection mylar on the thermal pad.
3. Align the notch on the M.2280 solid-state drive with the tab on the M.2 card slot on the system board.
4. Slide the M.2280 solid-state drive into the M.2 card slot on the system board.
5. Replace the screw (M2x3.5) to secure the M.2280 solid-state drive to the system board.
Next steps
1. Install the
disk-drive
cage.
2. Install the
3.5-inch hard drive
3. Install the
2.5-inch hard drive
4. Install the
front
bezel.
5. Install the
side
cover.
6. Follow the procedure in
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch hard drive
5. Remove the
3.5-inch hard drive
6. Remove the
disk-drive
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
60
Removing and installing Customer Replaceable Units (CRUs)
if applicable.
if applicable.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.
Advertisement
Table of Contents
