Table of Contents
Advertisement
Problem
The drum is full but the
display shows 0.0 kg.
The drum light does not
go on.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
14. EMERGENCY DOOR OPENING
In case of power failure or appliance
failure the appliance door remains
locked. The washing programme
continues, when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock feature.
Before opening the door:
CAUTION!
Make sure that the water
temperature and the
laundry are not hot. Wait
till they cool down, if
necessary.
CAUTION!
Make sure that the drum is
not rotating. Wait till the
drum stops rotating, if
necessary.
Make sure that the water
level inside the drum is
not too high. Proceed with
an emergency drain, if
necessary (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
Possible solution
You loaded the laundry before activating the appliance.
Press button Auto Off to deactivate the appliance.
Empty the drum and obey to the necessary steps. (Refer to
'Loading the laundry')
Make sure that you activate the appliance. Refer to 'Daily
Use'.
To open the door, proceed as follows:
1. Press the button AutoOff to switch
2. Disconnect the mains plug from the
3. Open the filter flap.
4. Keep the emergency unlock trigger
5. Take out the laundry and then close
6. Close the filter flap.
the appliance off.
mains socket.
pulled downward and, at the same
time, open the appliance door.
the appliance door.
ENGLISH
27
Advertisement
Table of Contents
