Table of Contents
Advertisement
13.4 Setting a programme
If you wish to change the
automatic detergent or fabric
softener dosage, enter the
AutoDose configuration
mode before proceeding
with any programme setting.
The configuration mode may
cancel temporary settings.
Please refer to "AutoDose
configuration mode"
paragraph in "The AutoDose
Technology (Autodosing)"
chapter.
1. Turn the programme dial to select the
desired washing programme. The
related programme indicator comes
on.
The indicator of the Start/Pauze
button flashes.
The display shows an indicative
programme duration, the maximum
declared load for the set programme
(only for a few seconds), the default
temperature, the default spin speed and
the washing phase indicators (when
available).
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators come on in the
display and the given information
changes accordingly.
In case a selection is not
possible, no indicator
comes on and an acoustic
signal sounds.
13.5 Starting a programme
WARNING!
Make sure that the detergent
dispenser is firmly closed,
otherwise programme won't
start.
Touch the Start/Pauze
the programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing.
The programme starts, the door is
locked. The display shows the indicator
13.6 Starting a programme
with the Klaar over option
1. Touch this repeatedly until the
2. Touch the Start/Pauze
The drum starts rotating to perform the
ProSense estimation, if foreseen in the
selected programme.
3. The appliance starts the countdown
To change or cancel this
option:
1. Switch the appliance off by means of
2. Switch the appliance on again.
3. Set the programme again.
13.7 The ProSense load
detection
After setting a washing programme, the
the programme supports it.
After touching the Start/Pauze
button, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
button to start
.
The drain pump can operate
shortly before the appliance
fills water.
display shows the desired time within
the programme should end. The
indicator
comes on.
to the end of the programme and the
programme will start at the right
moment for ending at the time set
through this option.
the Aan/Uit button.
The programme duration in
the display is referred to a
medium/high load.
icon lights up on the display if
first 30 seconds: the indicator
flashes, the bars under the
icon move back and forth and the
drum rotates shortly.
ENGLISH
39
button.
Advertisement
Table of Contents
